Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Managing 2960G (ports 21 to 24)

Is there a specific reason why i'm not able, in CLI or web interface, to manage any of the trunk ports 21st to 24th ? We're plugged to a IAP's router which is configured 10mb full and the port is giving me Half-duplex. I can't change it from Auto, i don't have any choice than Auto.. To make it working well, i have to plug it in the 20th port and set it to Auto Speed but Full-Duplex.

So, can we manage those 4 ports and if yes, how?

Thanks

2 REPLIES
Bronze

Re: Managing 2960G (ports 21 to 24)

If I remember correctly, those four ports are dual-ports, i.e. they can either be RJ45 or SFP. This means that you ahve to definee media-type before you can configure speed/duplex.

interface g0/21

media-type [rj45|sfp]

HTH

New Member

Re: Managing 2960G (ports 21 to 24)

It works! Thank you very much. Pretty interesting to know though.

good day

221
Views
0
Helpful
2
Replies