Just a little advice about the setup I am looking at. I have an edge router 2651XM with a WIC-ADSL card in. I have a PIX 501 and and a Catalyst 2940. Is it possible and a reasonable idea to host a DMZ using a a couple of dedicated ports on the switch? If so, would it be an idea to host it on a dedicated port based VLAN? I want to host a website on the DMZ and my current thoughts on my setup are:
PSTN -> WIC in 2651
2651 -> PIX external I/F using one router I/F
PIX -> Catalyst
Catalyst -> 2651 on the second router I/F for routing on the switch
CAT2940 is a pure layer 2 device. Therefore, you can configure two vlans on it to make it as two virtual switches, for example, configuring all ports for DMZ in one vlan and the rest ports in the other vlan.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...