Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Manual Allocation of dsp in router

Hi

Can I do a manual allocation of the dsp resources in router?

1. If I have 3 PVDM, can I assign one PVDM solely for conference, one PVDM solely for transcoding?

2. Can I sub-divide a PVDM to split across differently functionalities, eg. conferencing use 1dsp, transcoding use another 1dsp out of the same PVDM?

My understanding is dsp is "automatically" assigned across the functionalities, like E1, conferencing, transcoding.

Please correct me if I am wrong.

Thanks

1 REPLY

Re: Manual Allocation of dsp in router

Hi

Can I do a manual allocation of the dsp resources in router?

1. If I have 3 PVDM, can I assign one PVDM solely for conference, one PVDM solely for transcoding?

2. Can I sub-divide a PVDM to split across differently functionalities, eg. conferencing use 1dsp, transcoding use another 1dsp out of the same PVDM?

My understanding is dsp is "automatically" assigned across the functionalities, like E1, conferencing, transcoding.

Please correct me if I am wrong.

Thanks

Hi,

Check out the below link hope that helps

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html#wp1003287

Ganesh.H

Remeber to rate the helpful post

312
Views
0
Helpful
1
Replies
CreatePlease login to create content