Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Mapping of private IP to a private IP on another segment

Hi Experts,

A client is migrating his servers to another segment connected on the same router to isolate those servers from user PCs. The migration would cause a change in ip addressing of the servers however the problem is that some of the softwares running on the user PCs were already hard coded pointed to the current ip's of the servers. The client requires the migration to be seamless and It will be an issue if those servers ip will be changed once transffered on the other segment.What im thinking is if we were able to map the current ip's of the servers to those ip's that is allocated for them on the other segment, is this doable? its just like static nat of private ip's to public ip's, but in this case private ip to private ip on another segment? and how can i do that?

Right now Internet connectivity is on FastEthernet 0/0 while currently the servers and users are on 192.168.1.0/24 network on FastEthernet 0/1. The client is thinking of migrating the servers to 172.16.1.0/24 on FastEthernet 0/2 which is on the same router.

any help would be much appreciated

Jonjon

2 REPLIES
Cisco Employee

Re: Mapping of private IP to a private IP on another segment

Hello,

Please try the following:

interface FastEthernet 0/0

Description LAN Segment

IP address

ip nat enable

exit

interface FastEthernet 0/1

Description New Segment

IP address

ip nat enable

exit

For the first Server:

access-list 101 permit ip host

route-map Server1

match ip address 101

exit

ip nat source static route-map Server1

For the Second Server:

access-list 102 permit ip host

route-map Server2

match ip address 102

exit

ip nat source static route-map Server2

Hope this helps.

Regards,

NT

New Member

Re: Mapping of private IP to a private IP on another segment

Hi Nagaraja,


Thanks for the reply. I'm still testing this configuration. Update you as soon as im finished testing.

regards,

Jon

331
Views
0
Helpful
2
Replies
CreatePlease to create content