Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Marking all inbound packets to DSCP=EF

I need to mark all the traffic arriving at a particular switcg port with a dscp value of EF.

I have the following configuration but as best I can tell its not working. If I run show access list the hit counter never increments but when I sniff on the port I am applying the service-map to I see a mountain of UDP traffic.

Any thoughts would be helpful - thanks.

access-list 105 permit udp host 10.100.120.120 any

class-map match-all VOIP

match access-group 105

!

!

policy-map SETDSCP

class VOIP

set dscp ef

interface GigabitEthernet7/48

switchport

switchport access vlan 200

switchport mode access

no ip address

speed 1000

duplex full

mls qos statistics-export

mls qos trust cos

spanning-tree portfast

service-policy input SETDSCP

4 REPLIES
Hall of Fame Super Blue

Re: Marking all inbound packets to DSCP=EF

Which switch type are you using ?

Jon

New Member

Re: Marking all inbound packets to DSCP=EF

THIS IS ON A 6509 RUNNING IOS Version 12.2(18)SXF11

Hall of Fame Super Blue

Re: Marking all inbound packets to DSCP=EF

Do you want to mark ALL traffic as EF ?

If so you should remove the "mls qos trust cos" statement because you don't want to trust any Cos values received you simply want to set the value to EF.

Jon

New Member

Re: Marking all inbound packets to DSCP=EF

Run a span session on the vlan interface and filter it to only display the IP address in question. That will show you if the traffic is being marked.

It's better to span the VL interface and not the physical port as I think the traffic coppied to the span session is taken before any manipulation, i.e. before the DSCP markings would be added.

Have you enabled QoS globally?

802
Views
0
Helpful
4
Replies