Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Maxage time when selecting root port

Folks, I understand that Maxage is the time a given switch will wait to hear BDPU's before it decides to elect root port. That said, I would answer e) for the question below. The correct answer according to the book is b). I can't understand why the Maxage time in this case is on the root bridge though. If the root bridge may even be down in this scenario why not consider the Maxage at the non-root switch?

1) Assume that a non-root

802.1d switch has ceased

to receive Hello BPDus.

Which SP setting determines

how long a non-root switch

waits before trying to choose

a new Root Port?

a) Hello time setting on the root

b) Maxage timer setting on the root

c) Forwrd Delay timer setting on the Root

d) Hello timer setting on the non-root switch

e) Maxage timer setting on the non-root switch

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: Maxage time when selecting root port

Marlon

The answer is b) because the timers that are used by all switches are the root bridge timers and not the local switch timers.

So prior to the loss of the BPDUs all switches would have received BPDUs from the root bridge and used the timers that the root bridge announced. If the root bridge goes down the timers learnt from the root bridge are still used.

Jon

2 REPLIES
Hall of Fame Super Blue

Re: Maxage time when selecting root port

Marlon

The answer is b) because the timers that are used by all switches are the root bridge timers and not the local switch timers.

So prior to the loss of the BPDUs all switches would have received BPDUs from the root bridge and used the timers that the root bridge announced. If the root bridge goes down the timers learnt from the root bridge are still used.

Jon

Community Member

Re: Maxage time when selecting root port

Oh!! Thanks.

195
Views
0
Helpful
2
Replies
CreatePlease to create content