07-30-2007 01:06 AM - edited 03-05-2019 05:34 PM
I have a Router MC3800, that I had to do a password recovery procedure, and after that, I do my configuration, wr mem, check the startup config and the running config, and it looks fine, but when I do a reboot, the router loses all the configuration. help?
07-30-2007 01:13 AM
Hi diastiago,
I know this might be a dumb question, but did you remember to set your configuration register back to the original value (before you went into password recovery mode)? I suppose that would stick you back into ROMMON mode, but I'm not exactly sure what you're looking at...does the router come back to initial configuration mode, or how?
Best of Luck,
Jason
07-30-2007 02:16 AM
Thanks, I forgot to run the configure memory and the config-register 0x2102 commands
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: