Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

MDS 9513 MGMT0 interface not passing any data

On my MDS 9513 MGMT0 interface i cannot ping anything apart from my own IP address. I cant even ping anything on my own subnet.

The interface connection is showing as up up and is not displaying any errors and does not have a speed/duplex mismatch. can anyone shed some light on this issue for me?

thanks in advance

ian

1 REPLY
Silver

Re: MDS 9513 MGMT0 interface not passing any data

Make sure you have configured default gateway. You need to explicitly configure a default gateway to connect to the switch and send IP packets or add a route for each subnet. The management port (mgmt0) is autosensing and operates in full duplex mode at a speed of 10/100/1000 Mbps. Autosensing supports both the speed and the duplex mode. On a Supervisor-1 module, the default speed is 100 Mbps and the default duplex mode is auto. On a Supervisor-2 module, the default speed is auto and the default duplex mode is auto.

For further information click this link.

http://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_3_x/configuration/guides/cli_3_3/intf.html#wp1206921

628
Views
0
Helpful
1
Replies
CreatePlease to create content