09-28-2013 12:33 AM - edited 03-07-2019 03:43 PM
Hi ,
I am looking information on the metro ethernet switch , the IOS going to load is me360x-universalk9-tar.152-2.S.tar
As I checked IOS fetaure of this file , it not included EIGRP ( file is attached) . cisco documentation says to run the routing protocol need IP base license
at cisco configuration tool , while ordering the switch , the tool says the IP base license ME3600X-I is default product and no need to order separately.
would llike to check am I good with this to run EIGRP routing protocol with loaded image : me360x-universalk9-tar.152-2.S.tar
Thnak you
Lerner
Solved! Go to Solution.
09-28-2013 01:55 AM
HTH
Regards
Inayath
*Plz rate if usefull.
09-28-2013 01:55 AM
HTH
Regards
Inayath
*Plz rate if usefull.
09-30-2013 01:11 AM
Hi Sharieff ,
I gone throgh this , If you see attached fetaure set , I am no where seeing other IPV4 routing protocols except OSPF for the IOS me360x-universalk9-tar.152-2.S.tar , here I have concern . if you tested it then please let me know
Regards
Lerner
10-03-2013 05:45 AM
All,
Image Name: me360x-universalk9-mz.152-4.S.bin
Image Feature: IP|LAYER_3|PLUS|SSH|3DES|MIN_DRAM_MEG=128
Module name = me3600 Next reboot level = MetroIPAccess and License = MetroIPAccess
it supports , by default license Metro IP access with IOS , I am able to configure EIGRP
thank you
Lerner
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: