09-28-2013 12:33 AM - edited 03-07-2019 03:43 PM
Hi ,
I am looking information on the metro ethernet switch , the IOS going to load is me360x-universalk9-tar.152-2.S.tar
As I checked IOS fetaure of this file , it not included EIGRP ( file is attached) . cisco documentation says to run the routing protocol need IP base license
at cisco configuration tool , while ordering the switch , the tool says the IP base license ME3600X-I is default product and no need to order separately.
would llike to check am I good with this to run EIGRP routing protocol with loaded image : me360x-universalk9-tar.152-2.S.tar
Thnak you
Lerner
Solved! Go to Solution.
09-28-2013 01:55 AM
HTH
Regards
Inayath
*Plz rate if usefull.
09-28-2013 01:55 AM
HTH
Regards
Inayath
*Plz rate if usefull.
09-30-2013 01:11 AM
Hi Sharieff ,
I gone throgh this , If you see attached fetaure set , I am no where seeing other IPV4 routing protocols except OSPF for the IOS me360x-universalk9-tar.152-2.S.tar , here I have concern . if you tested it then please let me know
Regards
Lerner
10-03-2013 05:45 AM
All,
Image Name: me360x-universalk9-mz.152-4.S.bin
Image Feature: IP|LAYER_3|PLUS|SSH|3DES|MIN_DRAM_MEG=128
Module name = me3600 Next reboot level = MetroIPAccess and License = MetroIPAccess
it supports , by default license Metro IP access with IOS , I am able to configure EIGRP
thank you
Lerner
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide