Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Memory Capacity on Catalyst 6513

How do I verify that the following have been installed in a Catalyst 6513 switch:

MEM-SUP720-SP-1GB

MEM-MSFC3-1GB

3 REPLIES
Cisco Employee

Re: Memory Capacity on Catalyst 6513

Hi Peter,

If you issue a "show version" you can see the MSFC DRAM which should display 1 GB in total and when you issue "remote command switch sh version" you will get the DRAM installed onm supervisor engine which should be 1 GB in total.

If you have any doubt please paste the output of both the commands.

HTH,

Ankur

*Pls rate all helpfull post

New Member

Re: Memory Capacity on Catalyst 6513

Thanks, Ankur.

Silver

Re: Memory Capacity on Catalyst 6513

Post your show version.

-Hoogen

111
Views
0
Helpful
3
Replies