Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

metal thing in slot on back of supervisor. what is this?

Hi all, I'm trying to find out what this metal item is in a slot / hole in the back of the supervisor. See the attached picture. My line cards dont have this and it seems to stop the supervisor sitting in the chassis correctly. Its a sup2-2ge in a 6509. Any ideas? Thanks, Tom
Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Green

Hi,With 6500 chassis you can

Hi,

With 6500 chassis you can only install
supy cards in specific slots.

see this link:-
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/hardware/Module_Installation/Sup_Eng_Guide/supe_gd/01overvw.html#wp1069525

Looking at your photo (6509 chasis) and that you say you 
a sup2-3ge.

Your SUP2 MUST be installed in slot 1 or 2

The metal blocks prevent the card from being installed in the wrong slots 

Regards
Alex

Regards, Alex. Please rate useful posts.
2 REPLIES
Green

Hi,With 6500 chassis you can

Hi,

With 6500 chassis you can only install
supy cards in specific slots.

see this link:-
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/hardware/Module_Installation/Sup_Eng_Guide/supe_gd/01overvw.html#wp1069525

Looking at your photo (6509 chasis) and that you say you 
a sup2-3ge.

Your SUP2 MUST be installed in slot 1 or 2

The metal blocks prevent the card from being installed in the wrong slots 

Regards
Alex

Regards, Alex. Please rate useful posts.
New Member

Hi Alex,Many thanks for your

Hi Alex,

Many thanks for your response that is exactly it! That document details it and I had just not seen this document, I'd read elsewhere that all the other supervisors go in slot 5 or 6 so I couldn't figure out why this one wouldn't go.

Thanks so much for your response.

Regards,

Tom

55
Views
0
Helpful
2
Replies
CreatePlease to create content