I'm in the process of migrating, with a new server setup using CUCM 7, to a 3845 gateway from out 2821. I'm having trouble getting the VWIC2-1MFT-T1E1 to register with the CUCM server. Also, and more perplexing to me, when I run a "sho mgcp end" both our interfaces don't have any endpoints listed. To my knowledge I have everything configured properly on the CUCM server. I'm also using "dial-peer voice 1 pots" the service is set to "MGCPAPP" and the port is using "controller t1 0/0/0."
I'm out if ideas at this point. Anyone have any? I have run "no mgcp" - "mgcp" a few times now.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.