Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mhsrp groups

Hi all, can anyone tell me why we would use these, is it so we could utilise 2 routers rather than one, for 2 different lans ?

1 REPLY
Silver

Re: mhsrp groups

This would be done for load sharing purpose. As you would know in the HSRP config the load (traffic) is passing through only one router at any given time. But in MHSRP you could send one lan traffic through one of the active routers and another throught the other active router. You achieve load sharing(not load balancing).

HTH

Hoogen

104
Views
0
Helpful
1
Replies