Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MIB value for Interface transceiver threshold

Does anyone know the MIB value equivalent to "show interface transceiver threshold". There is a supported trap but despite many searches I have not found this yet. I want to monitor the optical power on the transceiver. I did previously ask on the network management forum but have not resolved this.

1 REPLY
Bronze

Re: MIB value for Interface transceiver threshold

The "show interface transceiver CLI" takes nearly 2 minutes to execute. show interfaces transceiver :To display diagnostic-monitoring data for all interfaces that have transceivers installed, use the show interfaces transceiver command.

show interfaces {{[int_name] transceiver {[detail | calibration]} | {transceiver [module

mod] | detail [module mod] | calibration [module mod]}}

552
Views
0
Helpful
1
Replies