10-18-2010 07:41 AM - edited 03-06-2019 01:34 PM
I'm trying to implement the following configuration on a Catalyst 4506 running 12.1(20r)EW1.
We have a three MS servers clusterd together. Two of them are on the same 4506.
When I try to enter the static mac address entry I am only allowed to enter one physical port.
switch(config)# mac-address-table static 02bf.0a1b.68fd vlan 20 interface FastEthernet5/8 ?
<cr>
If I try to do two seperate entries the first one is overwritten.
Any suggestions?
Solved! Go to Solution.
10-18-2010 08:01 AM
Hello Tobin,
if you are really running 12.1(20r)EW1 I would suggest an IOS image upgrade as your version is rather old.
This can easily explain why you cannot enter the required command
I have the same problem on a C4500 running 12.2(20)EW
switch(config)#$-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5
mac-address-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5
^
% Invalid input detected at '^' marker.
Hope to help
Giuseppe
10-18-2010 08:01 AM
Hello Tobin,
if you are really running 12.1(20r)EW1 I would suggest an IOS image upgrade as your version is rather old.
This can easily explain why you cannot enter the required command
I have the same problem on a C4500 running 12.2(20)EW
switch(config)#$-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5
mac-address-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5
^
% Invalid input detected at '^' marker.
Hope to help
Giuseppe
10-18-2010 08:22 AM
Hi
switch#sh run | i mac.*static
mac address-table static 1111.1111.1111 vlan 10 interface Gi1/2 Gi2/2
On 12.2(53)SG2
HTH
Dan
10-18-2010 08:27 AM
Hello Dan,
thanks this confirms that an IOS upgrade is necessary for the original poster as I have suspected
Hope to help
Giuseppe
10-18-2010 11:24 AM
Thank you both. That explains it. Gives me a good excuse to upgrade the IOS.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: