Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Microsoft Load Balancing on 4506

I'm trying to implement the following configuration on a Catalyst 4506 running 12.1(20r)EW1.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a0080a07203.shtml#mm

We have a three MS servers clusterd together. Two of them are on the same 4506.

When I try to enter the static mac address entry I am only allowed to enter one physical port.

switch(config)# mac-address-table static 02bf.0a1b.68fd vlan 20 interface FastEthernet5/8 ?

     <cr>

If I try to do two seperate entries the first one is overwritten.

Any suggestions?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Microsoft Load Balancing on 4506

Hello Tobin,

if you are really running 12.1(20r)EW1 I would suggest an IOS image upgrade as your version is rather old.

This can easily explain why you cannot enter the required command

I have the same problem on a C4500 running 12.2(20)EW

switch(config)#$-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5

mac-address-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5

                                                               ^

% Invalid input detected at '^' marker.

Hope to help

Giuseppe

4 REPLIES
Hall of Fame Super Silver

Re: Microsoft Load Balancing on 4506

Hello Tobin,

if you are really running 12.1(20r)EW1 I would suggest an IOS image upgrade as your version is rather old.

This can easily explain why you cannot enter the required command

I have the same problem on a C4500 running 12.2(20)EW

switch(config)#$-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5

mac-address-table static 02bf.0a1b.68fd vlan 20 interface g5/4 g5/5

                                                               ^

% Invalid input detected at '^' marker.

Hope to help

Giuseppe

Re: Microsoft Load Balancing on 4506

Hi

switch#sh run | i  mac.*static

mac address-table static 1111.1111.1111 vlan 10 interface Gi1/2 Gi2/2

On 12.2(53)SG2

HTH

Dan

Hall of Fame Super Silver

Re: Microsoft Load Balancing on 4506

Hello Dan,

thanks this confirms that an IOS upgrade is necessary for the original poster as I have suspected

Hope to help

Giuseppe

New Member

Re: Microsoft Load Balancing on 4506

Thank you both. That explains it. Gives me a good excuse to upgrade the IOS.

352
Views
0
Helpful
4
Replies
CreatePlease to create content