Case study: I am seeking help as I am attempting to test the .1Q functionality of Microsoft Virtual PC (only). What I have done is connected a PC w 1gig NIC configured for .1Q tagging and connected it to a Cat 3750 trunk port. I configured 3 VLAN (one per virtual environment) and I created a loopback interface to ping too.
Problem: PING not successful. I am able to see the VLAN tagged on the 3750 and when I show ARP on the 3750 I do see the MAC of the Virtual PC with the correct VLANID but the switch will not route the packet to the LO int. Hence, PING failure. I tried with both no routing and with EIGRP both, to no avail.
Attached is a diagram with info, the IOS is LAN IP not sure version but there are no other config’s on the 3750 it is clean fresh out of the box. I have to use this set as I am limited additional devices due to security policies.
Any suggestions or recommendations would be greatly appreciated. I am leaning towards Microsoft VM the root cause but just not sure. The ping should route and respond.
Re: Microsoft Virtual Machine Issues w .1Q routing
Thanks, this is a duplicate thread and I have been trying to find a way to delete or remove it under- ACTIONS. But to no avail.Any advise? I am new to this forum and am not familuar with all the functionality yet. I appriciate your help.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...