my company use vlan1 for lots servers and I would like to "migrate" them to another VLAN.
but how can I do that without cuting down the whole production. these servers need to always communicate each others and to others servers on other VLAN..(trough the our ISL router -an msfc on our 6509- which has VLANs interface configured for routing) ?
In fact I would like that VLAN 1 be "bridged" to vlan10 in order to let me move port in VLAN1 to VLAN10 progessively.
I put a bridge-group for vlan6 and 10, enabled bridge irb, activated bridging and routing for this bridge-group. boxes in vlan6 and 10 can communicate together (same ip subnet) but communication with the gateway is impossible..
it's impossible for boxes in vlan 10 to get mac adress of their default gateway which is interface vlan6. for other boxes in vlan 6, no problem to reach the gateway and traffic being routed.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.