09-04-2008 09:38 AM - edited 03-06-2019 01:11 AM
Folks,
I have two 6509 CatOS switch with IOS running in MSFC. I tried to install WiSM in my network but later found that CatOs doesn't support WiSM. So, I am planning to upgrade the switch to Native mode of operation ( IOS both on switch and MSFC) and will work on Wism. I just like to have you experience in the process. What are the steps, considerations and requirements to this migration with no ( I doubt ??) or less downtime.
I would appreciate if you have any idea or experience to share on this regards.
09-04-2008 09:58 AM
09-04-2008 10:09 AM
Hi,
There is a good Cisco link to answer all your questions including the migration steps:
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a0080816fbc.shtml
P.S> Please rate the post if you find it useful.
HTH,
Sameer
09-04-2008 10:27 AM
Thanks guys
Let me go through it and get back to you guys with my concerns.
subharose
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: