Migrating from explicit passive-interface to passive-interface default
Migrating from an explicit passive-interface configuration to a passive-interface default configuration followed by no-passive interface on interfaces where you want to get routing updates. How long do you have before neighbor is lost? You are not able to enter the no-passive statements until after the passive-interface default is coded. Is this possible without an outage i.e. to make this transition without loosing the neighbor? My thinking is that you would have to beat the OSPF dead timer sequence.
Migrating from explicit passive-interface to passive-interface d
I agree with Rolf that the quickest and most expedient way to get the change in is to put the changes into a file and tftp to the device. My impression is that you may still have a loss of neighbor relationship.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...