Migration from catalyst 5000 switch to catalyst 3750 stack
I am just about to migrate a portion of a production network from an old CISCO catalyst 5000 to a CISCO catalyst 3750 stack and was wondering if there are any good methods/run orders to transform the CatOS configuration to IOS configuration. Doing it line by line seems rather time consuming and not being an expert on CatOS commands doesn't help.
So... looking around I've tried to find a few commands without success that I otherwise think might help;
show run interface <interface-ID>
show interfaces trunk
show interface switchport
So any tips or solution to the show commands listed would be highly appreciated.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...