Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Minor Error on Sup720

Has anyone came across this?

Online Diagnostic of Supervisor Engine 720 (Hot): Test 35, Error code 43 (DIAG_CHECK_ETHER_PAK_ERROR)

The complete diagnostic level was enabled on the system:

#show diagnostic result module 6 failure detail

Current bootup diagnostic level: complete

Overall Diagnostic Result for Module 6 : MINOR ERROR
Diagnostic level at card bootup: complete

Test results: (. = Pass, F = Fail, U = Untested)

35) TestUnusedPortLoopback:

Port 1 2 3 4 5
-------------------
U U F U F


Error code ------------------> 43 (DIAG_CHECK_ETHER_PAK_ERROR)
Total run count -------------> 2457255
Last test execution time ----> Sep 16 2014 10:14:59
First test failure time -----> Jun 13 2012 11:37:30
Last test failure time ------> Sep 16 2014 10:14:59
Last test pass time ---------> Jun 13 2012 11:36:23
Total failure count ---------> 717278
Consecutive failure count ---> 717278

#show module 6
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
6 5 Supervisor Engine 720 10GE (Hot) VS-S720-10G

Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
6 001d.45e2.0058 to 001d.45e2.005f 2.0 8.5(2) 12.2(33)SXH4 Ok

Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
6 Policy Feature Card 3 VS-F6K-PFC3C  1.0 Ok
6 MSFC3 Daughterboard VS-F6K-MSFC3  1.0 Ok

Mod Online Diag Status
---- -------------------
6 Minor Error

 

  • LAN Switching and Routing
Everyone's tags (2)
1 REPLY
Cisco Employee

Hardware defect. RMA the

Hardware defect. RMA the module .

please go ahead and replace the module. In the mean time just give a try by reseating the same.

HTH

Inayath

********Plz dont forget to rate usefull posts******

404
Views
0
Helpful
1
Replies
This widget could not be displayed.