I would appreciate if someone could tell me if device Catalyst 4510R-E supports MLDv2 snooping when use of vlan mapping to a vlan tunnel QinQ design.
MLDv2 snooping on vlan 100. Map the vlan 100 to e.g. 1:1000. Multicast router belongs to 1:1000. MLDv2 report is sent be CPE to join multicast group. Cat4500E snoops this report to build L2 forwarding entry for this multicast group.
Thank you for your response and where I could find the documentation concerning QinQ, Vlan mapping and MLDv2 snooping.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...