Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MLS on 6500 with sup2T

Cisco 6500 with 2T supervisor engine with following software

Cisco IOS Software, s2t54 Software (s2t54-IPSERVICESK9-M), Version 15.0(1)SY1, RELEASE SOFTWARE (fc4)

The problem is that, I am not able to configure Multilayer Switching (MLS) (mls rp ip) in the global config command. Although the "mls" is visible on the config menu. but when I say "mls ?", the router prompt "unrecognize command"

Not sure if SUP 2T support MLS or it come with different name .

I hope to get your comments. Thanks !

Regards,

Umair

Everyone's tags (3)
1 REPLY
Hall of Fame Super Gold

MLS on 6500 with sup2T

Try the command "ip routing".

687
Views
0
Helpful
1
Replies
CreatePlease to create content