09-12-2014 08:14 AM - edited 03-07-2019 08:44 PM
Hello !
My switch is Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.0(2)EX5, RELEASE SOFTWARE (fc1)
I try to disabled mls qos only for one interface, but when i do it, mls qos is globally disabled. Is it possible to do it ?
XXX#show mls qos
QoS is enabled
QoS ip packet dscp rewrite is enabled
XXX#conf t
Enter configuration commands, one per line. End with CNTL/Z.
XXX(config)#interface gigabitEthernet 1/0/5
XXX(config-if)#no mls qos
XXX(config)#exit
XXX#
XXX#show mls qos
QoS is disabled
QoS ip packet dscp rewrite is enabled
Thanks in advance for your help !!
Denis
Solved! Go to Solution.
09-12-2014 11:32 AM
Hi Denis,
You cant disable the QOS on per interface on 2960 devices.
By default, QoS is disabled. When we enable QoS all ports
will be assigned to queue-set 1. We can configure up to two
different queue-sets.
Hence if you remove the qos out of the interface it would be disabled globally as well.
HTH
09-12-2014 11:32 AM
Hi Denis,
You cant disable the QOS on per interface on 2960 devices.
By default, QoS is disabled. When we enable QoS all ports
will be assigned to queue-set 1. We can configure up to two
different queue-sets.
Hence if you remove the qos out of the interface it would be disabled globally as well.
HTH
09-12-2014 11:35 AM
Were in following things mentioned in the below document can be disabled individually on the port.
http://3c3cc.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-2_2_e/consolidated_guide/configuration_guide/b_1522e_consolidated_2960x_cg.pdf
Do a search for " no mls qos " you will get more options here.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: