09-12-2014 08:14 AM - edited 03-07-2019 08:44 PM
Hello !
My switch is Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.0(2)EX5, RELEASE SOFTWARE (fc1)
I try to disabled mls qos only for one interface, but when i do it, mls qos is globally disabled. Is it possible to do it ?
XXX#show mls qos
QoS is enabled
QoS ip packet dscp rewrite is enabled
XXX#conf t
Enter configuration commands, one per line. End with CNTL/Z.
XXX(config)#interface gigabitEthernet 1/0/5
XXX(config-if)#no mls qos
XXX(config)#exit
XXX#
XXX#show mls qos
QoS is disabled
QoS ip packet dscp rewrite is enabled
Thanks in advance for your help !!
Denis
Solved! Go to Solution.
09-12-2014 11:32 AM
Hi Denis,
You cant disable the QOS on per interface on 2960 devices.
By default, QoS is disabled. When we enable QoS all ports
will be assigned to queue-set 1. We can configure up to two
different queue-sets.
Hence if you remove the qos out of the interface it would be disabled globally as well.
HTH
09-12-2014 11:32 AM
Hi Denis,
You cant disable the QOS on per interface on 2960 devices.
By default, QoS is disabled. When we enable QoS all ports
will be assigned to queue-set 1. We can configure up to two
different queue-sets.
Hence if you remove the qos out of the interface it would be disabled globally as well.
HTH
09-12-2014 11:35 AM
Were in following things mentioned in the below document can be disabled individually on the port.
http://3c3cc.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-2_2_e/consolidated_guide/configuration_guide/b_1522e_consolidated_2960x_cg.pdf
Do a search for " no mls qos " you will get more options here.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide