Module not responding to Keep Alive polling

[david.fernandes]

What are the possible causes for this syslog message?

PWRCYCLE Card in module 3, is being power-cycled off (Module not responding

to Keep Alive polling)

Over the past few months, I have seen this message pop up now and then on different 6509 access switches. The modules are WS-X6148A-GE-TX. I know the recommended action is to reseat the module but I'm wondering if anyone else has run across this type of issue.

[Giuseppe Larosa]

Hello David,

reseating the module can help and it did for us with a new installed C6500.

There can be issues with these specific linecards as well because they are the older ones.

Hope to help

Giuseppe