cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
563
Views
0
Helpful
2
Replies

Module, PFC3 & MSFC3 malfunctioning

rj.kapildev
Level 1
Level 1

Hi..

I gotta issue in ma switch WS-C6506-E, any possibilities to resolve tis issue ?? As even the user impact s there   Didn't rebooted since as switch is in critical network, on top of that incase of minor error vanish-off in rebooting, whereas here we facing major error on both primary vs secondary switch, any suggestion would be great and most welcome...

Mod Ports Card Type                              Model              Serial No.

--- ----- -------------------------------------- ------------------ -----------

5    2  Supervisor Engine 720 (Active)         WS-SUP720-3B       SAL1420HTU6

Mod MAC addresses                       Hw    Fw           Sw           Status

--- ---------------------------------- ------ ------------ ------------ -------

5  ----------------------------   5.10  8.5(3)       12.2(33)SXH8 MajFail

Mod  Sub-Module                  Model              Serial       Hw     Status

---- --------------------------- ------------------ ----------- ------- -------

  1  Centralized Forwarding Card WS-F6700-CFC       ---------------  4.1    PwrDown

  2  Centralized Forwarding Card WS-F6700-CFC      ----------------  4.1    Ok

  3  Centralized Forwarding Card WS-F6700-CFC       ----------------  4.1    Ok

  5  Policy Feature Card 3       WS-F6K-PFC3B       -----------------  2.6    MajFail

  5  MSFC3 Daughterboard         WS-SUP720          -----------------  4.1    MajFail

Mod  Online Diag Status

---- -------------------

  1  Not Applicable

  2  Minor Error

  3  Minor Error

  5  Major Error

Thanks in advance.

1 Accepted Solution

Accepted Solutions

glen.grant
VIP Alumni
VIP Alumni

  There is no way around it you are going to take some downtime.  Get a show tech and open a tac case , most likely the supervisor will have to be replaced , make sure they send you the new supervisor , pfc, and msfc cards .  They like to send them separate so you may have to put them together , usually there is instructions. Also check and make sure all power supplies and inputs look ok .

View solution in original post

2 Replies 2

glen.grant
VIP Alumni
VIP Alumni

  There is no way around it you are going to take some downtime.  Get a show tech and open a tac case , most likely the supervisor will have to be replaced , make sure they send you the new supervisor , pfc, and msfc cards .  They like to send them separate so you may have to put them together , usually there is instructions. Also check and make sure all power supplies and inputs look ok .

Thanks for your suggestion ...

Review Cisco Networking products for a $25 gift card