cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
561
Views
0
Helpful
2
Replies

Module, PFC3 & MSFC3 malfunctioning

rj.kapildev
Level 1
Level 1

Hi..

I gotta issue in ma switch WS-C6506-E, any possibilities to resolve tis issue ?? As even the user impact s there   Didn't rebooted since as switch is in critical network, on top of that incase of minor error vanish-off in rebooting, whereas here we facing major error on both primary vs secondary switch, any suggestion would be great and most welcome...

Mod Ports Card Type                              Model              Serial No.

--- ----- -------------------------------------- ------------------ -----------

5    2  Supervisor Engine 720 (Active)         WS-SUP720-3B       SAL1420HTU6

Mod MAC addresses                       Hw    Fw           Sw           Status

--- ---------------------------------- ------ ------------ ------------ -------

5  ----------------------------   5.10  8.5(3)       12.2(33)SXH8 MajFail

Mod  Sub-Module                  Model              Serial       Hw     Status

---- --------------------------- ------------------ ----------- ------- -------

  1  Centralized Forwarding Card WS-F6700-CFC       ---------------  4.1    PwrDown

  2  Centralized Forwarding Card WS-F6700-CFC      ----------------  4.1    Ok

  3  Centralized Forwarding Card WS-F6700-CFC       ----------------  4.1    Ok

  5  Policy Feature Card 3       WS-F6K-PFC3B       -----------------  2.6    MajFail

  5  MSFC3 Daughterboard         WS-SUP720          -----------------  4.1    MajFail

Mod  Online Diag Status

---- -------------------

  1  Not Applicable

  2  Minor Error

  3  Minor Error

  5  Major Error

Thanks in advance.

1 Accepted Solution

Accepted Solutions

glen.grant
VIP Alumni
VIP Alumni

  There is no way around it you are going to take some downtime.  Get a show tech and open a tac case , most likely the supervisor will have to be replaced , make sure they send you the new supervisor , pfc, and msfc cards .  They like to send them separate so you may have to put them together , usually there is instructions. Also check and make sure all power supplies and inputs look ok .

View solution in original post

2 Replies 2

glen.grant
VIP Alumni
VIP Alumni

  There is no way around it you are going to take some downtime.  Get a show tech and open a tac case , most likely the supervisor will have to be replaced , make sure they send you the new supervisor , pfc, and msfc cards .  They like to send them separate so you may have to put them together , usually there is instructions. Also check and make sure all power supplies and inputs look ok .

Thanks for your suggestion ...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card