Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Module, PFC3 & MSFC3 malfunctioning

Hi..

I gotta issue in ma switch WS-C6506-E, any possibilities to resolve tis issue ?? As even the user impact s there   Didn't rebooted since as switch is in critical network, on top of that incase of minor error vanish-off in rebooting, whereas here we facing major error on both primary vs secondary switch, any suggestion would be great and most welcome...

Mod Ports Card Type                              Model              Serial No.

--- ----- -------------------------------------- ------------------ -----------

5    2  Supervisor Engine 720 (Active)         WS-SUP720-3B       SAL1420HTU6

Mod MAC addresses                       Hw    Fw           Sw           Status

--- ---------------------------------- ------ ------------ ------------ -------

5  ----------------------------   5.10  8.5(3)       12.2(33)SXH8 MajFail

Mod  Sub-Module                  Model              Serial       Hw     Status

---- --------------------------- ------------------ ----------- ------- -------

  1  Centralized Forwarding Card WS-F6700-CFC       ---------------  4.1    PwrDown

  2  Centralized Forwarding Card WS-F6700-CFC      ----------------  4.1    Ok

  3  Centralized Forwarding Card WS-F6700-CFC       ----------------  4.1    Ok

  5  Policy Feature Card 3       WS-F6K-PFC3B       -----------------  2.6    MajFail

  5  MSFC3 Daughterboard         WS-SUP720          -----------------  4.1    MajFail

Mod  Online Diag Status

---- -------------------

  1  Not Applicable

  2  Minor Error

  3  Minor Error

  5  Major Error

Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: Module, PFC3 & MSFC3 malfunctioning

  There is no way around it you are going to take some downtime.  Get a show tech and open a tac case , most likely the supervisor will have to be replaced , make sure they send you the new supervisor , pfc, and msfc cards .  They like to send them separate so you may have to put them together , usually there is instructions. Also check and make sure all power supplies and inputs look ok .

2 REPLIES
Purple

Re: Module, PFC3 & MSFC3 malfunctioning

  There is no way around it you are going to take some downtime.  Get a show tech and open a tac case , most likely the supervisor will have to be replaced , make sure they send you the new supervisor , pfc, and msfc cards .  They like to send them separate so you may have to put them together , usually there is instructions. Also check and make sure all power supplies and inputs look ok .

New Member

Module, PFC3 & MSFC3 malfunctioning

Thanks for your suggestion ...

181
Views
0
Helpful
2
Replies
CreatePlease login to create content