08-17-2012 12:41 AM - edited 03-07-2019 08:23 AM
Hello everyone
when I do a show module in my cat 6509, the standby sup is saying unknown, it has the same IOS as the primary card.
what does this mean?
are there any tests I can run on the card?
cheers
Carl
08-17-2012 02:16 AM
Hi Carl, if your IOS matches across the cards then it's likely that your standby supervisor is either stuck in rommon or in a boot loop. You will need console access to recover it if that's the case. Have you tried to reseat it?
08-17-2012 06:59 PM
when I do a show module in my cat 6509, the standby sup is saying unknown, it has the same IOS as the primary card.
Card's either faulty or in ROMmon. Console into it to find out further.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: