Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Monitor an interface

I have cisco 2821 router and I want to monitor an ISDN BRI interface, in case the line goes down. I would then like the router to shut down the ethernet interface automatically, thus taking it of the network. This would allow my server to failover to another Router

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Monitor an interface

if you are using HSRP between RTR1 (with ISDN) and RTR2. you could have HSRP to track ISDN interface and make RTR2 active when ISDN fails, so no need to shut RTR1 Ethernet.

RTR1 & RTR2 needs to be on same VLAN.

There are other ways, but this is the most common one.

HTH

Sam

1 REPLY

Re: Monitor an interface

if you are using HSRP between RTR1 (with ISDN) and RTR2. you could have HSRP to track ISDN interface and make RTR2 active when ISDN fails, so no need to shut RTR1 Ethernet.

RTR1 & RTR2 needs to be on same VLAN.

There are other ways, but this is the most common one.

HTH

Sam

100
Views
0
Helpful
1
Replies