Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

monitor icmp traffic on C6509

Hi,

Both regular IP traffic and ICMP traffic are passing through the source port. C6509 provides the option of filtering vlan traffic during monitoring. But I don't have vlan traffic.

qa-c6509-c(config)#monitor session 1 filter ?

  vlan  SPAN filter VLAN

So I applied an access-list which only allows icmp traffic to be sent out of the monitoring port. But it does not work. Any suggestions?

thx,

Shelley

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

monitor icmp traffic on C6509

well if the source is a L3 port you don't have vlan tags in ingress ... so the vlan filter cannot work as per the doc I gave you.

Riccardo

4 REPLIES
Cisco Employee

monitor icmp traffic on C6509

Is your source port a trunk?

I am asking as SPAN vlan filtering works only on trunk ports and not on access ports.

In other word in order to filter by vlan the source traffic must have an actual vlan tag.

for more see

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015c612.shtml#terms

Riccardo

New Member

monitor icmp traffic on C6509

Hi Riccardo,

The problem is I only configured layer 3 ports in my topology.

thx,

Shelley

Cisco Employee

monitor icmp traffic on C6509

well if the source is a L3 port you don't have vlan tags in ingress ... so the vlan filter cannot work as per the doc I gave you.

Riccardo

Cisco Employee

monitor icmp traffic on C6509

Shelley,

please rate/close thread if there are no more questions.

R

1007
Views
10
Helpful
4
Replies