Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Monitor session - Local SPAN - small output

I am having difficulties with getting SPAN traffic over my WS-X6704-10GE (CFC).

CISCO7606

ios 12.2(33)SRE6, SUP720-3BXL

Trying to use the span feature, put the commands listed below in and they entered successfully, but the port is not being mirrored.

interface TenGigabitEthernet1/1

description PUBLIC

dampening

mtu 9216

ip address x.x.x.x x.x.x.x

interface TenGigabitEthernet1/2

mtu 9216

no ip address

monitor session 1 source interface tenGigabitEthernet 1/1

monitor session 1 dest interface tenGigabitEthernet 1/3

show monitor session 1 detail

Session 1

---------

Type                   : Local Session

Description            : -

Source Ports           :

RX Only            : None

TX Only            : None

Both               : Te1/1

Source VLANs           :

RX Only            : None

TX Only            : None

Both               : None

Source RSPAN VLAN      : None

Destination Ports      : Te1/3

Filter VLANs           : None

Dest RSPAN VLAN        : None

Source IP Address      : None

Source IP VRF          : None

Source ERSPAN ID       : None

Destination IP Address : None

Destination IP VRF     : None

Destination ERSPAN ID  : None

Origin IP Address      : None

IP QOS PREC            : 0

IP TTL                 : 255

show fabric utilization

slot    channel      speed    Ingress %     Egress %

1          0        20G            8            3

1          1        20G            3            8

4          0        20G            1            0

5          0         8G            0            0

6          0        20G            0            0

show fabric utilization

slot    channel      speed    Ingress %     Egress %

1          0        20G            8           20

1          1        20G           13            8

4          0        20G            0            0

5          0         8G            0            0

6          0        20G           12           12

Fabric utilization grow up.

TenGigabitEthernet1/1 is up, line protocol is up (connected)

5 minute input rate 868162000 bits/sec, 257246 packets/sec

5 minute output rate 2553331000 bits/sec, 322959 packets/sec

TenGigabitEthernet1/3 is up, line protocol is down (monitoring)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 45000 bits/sec, 80 packets/sec

Output rate too small.

On other shelf with WS-X6704-10GE (DFC) work fine.

Could anyone help look at whether my "monitor session" statements are correctly configured.

Thanks.

1 REPLY
Silver

Re: Monitor session - Local SPAN - small output

hello,

try

monitor session 1 source interface tenGigabitEthernet 1/1 both

monitor session 1 dest interface tenGigabitEthernet 1/3

Please Rate this information helps thanks

675
Views
0
Helpful
1
Replies
CreatePlease to create content