I am having difficulties with getting SPAN traffic over my WS-X6704-10GE (CFC).
CISCO7606
ios 12.2(33)SRE6, SUP720-3BXL
Trying to use the span feature, put the commands listed below in and they entered successfully, but the port is not being mirrored.
interface TenGigabitEthernet1/1
description PUBLIC
dampening
mtu 9216
ip address x.x.x.x x.x.x.x
interface TenGigabitEthernet1/2
mtu 9216
no ip address
monitor session 1 source interface tenGigabitEthernet 1/1
monitor session 1 dest interface tenGigabitEthernet 1/3
show monitor session 1 detail
Session 1
---------
Type : Local Session
Description : -
Source Ports :
RX Only : None
TX Only : None
Both : Te1/1
Source VLANs :
RX Only : None
TX Only : None
Both : None
Source RSPAN VLAN : None
Destination Ports : Te1/3
Filter VLANs : None
Dest RSPAN VLAN : None
Source IP Address : None
Source IP VRF : None
Source ERSPAN ID : None
Destination IP Address : None
Destination IP VRF : None
Destination ERSPAN ID : None
Origin IP Address : None
IP QOS PREC : 0
IP TTL : 255
show fabric utilization
slot channel speed Ingress % Egress %
1 0 20G 8 3
1 1 20G 3 8
4 0 20G 1 0
5 0 8G 0 0
6 0 20G 0 0
show fabric utilization
slot channel speed Ingress % Egress %
1 0 20G 8 20
1 1 20G 13 8
4 0 20G 0 0
5 0 8G 0 0
6 0 20G 12 12
Fabric utilization grow up.
TenGigabitEthernet1/1 is up, line protocol is up (connected)
5 minute input rate 868162000 bits/sec, 257246 packets/sec
5 minute output rate 2553331000 bits/sec, 322959 packets/sec
TenGigabitEthernet1/3 is up, line protocol is down (monitoring)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 45000 bits/sec, 80 packets/sec
Output rate too small.
On other shelf with WS-X6704-10GE (DFC) work fine.
Could anyone help look at whether my "monitor session" statements are correctly configured.
Thanks.
