Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

monitoring a port

I have set up a monitoring session on a 4507 switch. The intent for this session is to capture all internet traffic for filtering purposes. I configured the session using the following commands:

monitor session 1 source int "port"

monitor session 1 dest int "port"

The status indicates that the destination port is not receiving packets and it is not learning.

The interface on my filtering unit stops responding and I am wondering if I misseed something on my session that may be causing the interface to stop responding.

TIA.

2 REPLIES
New Member

Re: monitoring a port

try the following

monitor session 1 source int `port` ?

monitor session 1 source int `port` tx, rx, both

monitor session 1 dest int "port"

rest is fine you can try this it should work

New Member

Re: monitoring a port

Thanks, that help.

288
Views
3
Helpful
2
Replies