Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Monitoring QoS with IP SLA

Hi there, i want to monitoring QoS in a switched network with:

- A lot of 2960 (IOS 12.2(55)SE8) and

- 1 Layer 3 core switch 3560 (IOS 12.2(55)SE8)

I can make the switch as a "responder"

ip sla responder

But a can't make the ip SLA source:

ip sla monitor

(config)#ip sla ?

  <1-2147483647>          Entry Number

  enable                  Enable Event Notifications

  ethernet-monitor        IP SLAs Auto Ethernet configuration

  group                   Group Configuration or Group Scheduling

  key-chain               Use MD5 authentication for IP SLAs control message

  logging                 Enable Syslog

  low-memory              Configure Low Water Memory Mark

  reaction-configuration  IP SLAs Reaction-Configuration

  reaction-trigger        IP SLAs Trigger Assignment

  reset                   IP SLAs Reset

  responder               Enable IP SLAs Responder

  restart                 Restart An Active Entry

  schedule                IP SLAs Entry Scheduling

  slm                     Service Level Management

I new on these, i read some cisco documentation. I´m sorry if it confused

So, with 2960 and 3560 can't monitoring QOS?

Thanks a lot

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Monitoring QoS with IP SLA

Hi,

2960 only supports responder:

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_55_se/configuration/guide/swipsla.html

and you need IP Services image to have full feature on 3560:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_58_se/configuration/guide/swipsla.html

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
1 REPLY
Purple

Monitoring QoS with IP SLA

Hi,

2960 only supports responder:

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_55_se/configuration/guide/swipsla.html

and you need IP Services image to have full feature on 3560:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_58_se/configuration/guide/swipsla.html

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
175
Views
0
Helpful
1
Replies