Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Moving Sup-10G VSS from 6509 to 6513

Hi experts

I need your input on to best move Sup modules from 6509 to 6513 and preserve the VSS configurations.

Basically I'm upgrading 6513s which are the core of my production network.  6509s are in lab, so I install SUPs on 6509 and configured them and tested.

Now I need to move them to 6513s, without repeating all the work, most importally to minimise the down time.  the lab configuration is identical to production; line cares are the same, execpt slot numbers are different which will affect port numbers.

I really appreciate your input.

thank you.

1 REPLY
VIP Super Bronze

Re: Moving Sup-10G VSS from 6509 to 6513

Hi,

You defiantly need an outage window to do this, because most likely you have to reboot the switches more then once to get it working.

I have only done it with 6509 and never moved the config/Sup from 6509 to any other model.  As you noted the port and module numbering changes and you may have to make some changes to make them work in the 6513 chassis.  I would have a back up plan in case things do not work the way they should.

Good Luck,

Reza

379
Views
0
Helpful
1
Replies