Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mp-bgp redistribution

We have two sides we have configured iBGP between the two sides and there are same VRF's working on both sides , for which we want communication to work
also there are few static routes and ospf  on each vrf . on each sides .
when we configure mp-bgp and put below commands the static and ospf communcation , do we need too put commands redistribute static and redistribute ospf , i have been suggested if we do so there is possibilty of black hole . do advise

address-family ipv4 vrf VRF_A
  redistribute connected
exit-address-family

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

mp-bgp redistribution

there is no two way redistribution rt?

so you can go ahead... else tag the traffic while redistributing and filter the same

2 REPLIES
New Member

mp-bgp redistribution

there is no two way redistribution rt?

so you can go ahead... else tag the traffic while redistributing and filter the same

New Member

mp-bgp redistribution

Thanks for reply Sharon , BGP is already getting redistributed in OSPF , so I think I cannot redistribute OSPF in BGP . But I still can redistribute static to mp-BGP.

114
Views
0
Helpful
2
Replies
CreatePlease login to create content