Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MQC Qos on Sup6-E (Cat4500), Change DSCP to tx-queue mapping?!

With MQC is it possible to change the default DSCP to tx-queue mapping ?

if yes, how ?

With Sup6-E the command "qos maps dscp <xxx> to tx-queue <y>" does NOT exist.

thanks for the help.

Ps: which is the default tx-queue to dscp mapping with sup6-E ? Same as Sup V ?

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions

Re: MQC Qos on Sup6-E (Cat4500), Change DSCP to tx-queue mapping

The 6E uses MCQ based QoS. It supports up to 8 queues instead of the 4 queues supported by previous supervisors.  You identify the queues by creating a policy-map and applying it as an output service policy to a port.  See the configuration guide here:

http://www.cisco.com/en/US/customer/docs/switches/lan/catalyst4500/12.2/44sg/configuration/guide/qos.html#wp1531008

If you do not have a CCO you will need the PDF link. See the section specific to the 6-E.

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/44sg/configuration/guide/qos.pdf

1 REPLY

Re: MQC Qos on Sup6-E (Cat4500), Change DSCP to tx-queue mapping

The 6E uses MCQ based QoS. It supports up to 8 queues instead of the 4 queues supported by previous supervisors.  You identify the queues by creating a policy-map and applying it as an output service policy to a port.  See the configuration guide here:

http://www.cisco.com/en/US/customer/docs/switches/lan/catalyst4500/12.2/44sg/configuration/guide/qos.html#wp1531008

If you do not have a CCO you will need the PDF link. See the section specific to the 6-E.

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/44sg/configuration/guide/qos.pdf

967
Views
0
Helpful
1
Replies