Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MSFC to Supervisor

I am trying to access the supervisor cli from the msfc card. This device is setup to telnet directly to the msfc card. That's great, but, how do I get to the supervisor cli from there?

Any help is greatly appreciated.

thx,

Rick

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: MSFC to Supervisor

Hi Rick, try telneting to 127.0.0.11. That's the internal slot/proc address for the supervisor in slot 1. 127.0.0.12 would get you the msfc.

Hope this helps.

Actually, just tried this and got nowhere. You can telnet around the chassis fine from the console with those addresses, but not from within the msfc.

Try a show arp and look for an IP against a mac that is identical to the msfc mac except for an "f" as the last character. You should be able to telnet to that IP and get the switch console.

Ross

3 REPLIES
Bronze

Re: MSFC to Supervisor

Hi Rick, try telneting to 127.0.0.11. That's the internal slot/proc address for the supervisor in slot 1. 127.0.0.12 would get you the msfc.

Hope this helps.

Actually, just tried this and got nowhere. You can telnet around the chassis fine from the console with those addresses, but not from within the msfc.

Try a show arp and look for an IP against a mac that is identical to the msfc mac except for an "f" as the last character. You should be able to telnet to that IP and get the switch console.

Ross

New Member

Re: MSFC to Supervisor

Thank you Ross!

You rock man!

Rick

Bronze

Re: MSFC to Supervisor

Cool, I was trying it here and couldn't get back to the sup from the msfc except by the backdoor as it were!

Glad it worked for you.

Thanks for the rating :)

193
Views
0
Helpful
3
Replies