suppose we have 4 vlans 2,3,4,5 and they are in instance 10....if i want to make a perticular switch root for these vlans i will config them in mst instance 10 and then i can do root...for example
mst instance 10 vlan 2,3,4,5 root primary
i was looking at config and they have used prority 0 instaed of root primary what is the difference or is it a same thing???? what is the default prority and if we write 0 what happenes....thanks guys for looking
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...