Multi-homed VMware virtual switches and Cisco switches
I'm putting in a new VMware EMS server for testing, our first. I'm not going to run trunks to this server but it is going to be attached to two different Catalyst switches that are trunked together. Since the EMS server has it's own virtual ethernet switches do I have to be concerned with spanning tree? I usually have portfast on to switch ports that connect to servers should I not do that in this case? Any other considerations I should address that someone here has come accross?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...