Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

multicast and igmp on l2 switch

i have a 3750g with 12.25seb2 base ios. igmp is enabled and the switch has igmp querier enabled. i have a mc source and listener on the same switch. doing a packet trace i can see igmp reports and queries but on the switch i don;t get any status when i do "ip igmp groups" or "ip igmp membership". shouldn't i see the groups setup in teh switch?

2 REPLIES
Hall of Fame Super Silver

Re: multicast and igmp on l2 switch

Hello JSchweng,

if the switch is only L2 switch you may need to focus on igmp snooping show commands.

sh ip igmp snooping groups

sh ip igmp snooping querier

sh ip ip igmp groups is to be used on the L3 multicast router/switch

Hope to help

Giuseppe

New Member

Re: multicast and igmp on l2 switch

ok thanks - i think we looked at those commands but will check again

jschweng

338
Views
0
Helpful
2
Replies