Multicast Issue with ip pim rp-address static-override command
Having an issue with the ip pim rp-address x.x.x.x <access-list> override command. I want a specific mulitcast group to use the loopback address of the local first hop router as its RP instead of the auto-rp learned rendezvous point address. The override command should take presidence for the group specified in the acl over auto-rp.
After entering the command, I did a clear ip pim rp mapping as well as a clear ip mroute *. However, the auto rp learned RP address still shows as the RP for the specified override groups.
Anyone else seen this issue?
Trying this on a 3750G-24T running 12.2(25)SEC2. Also see the issue on 6509E Sup7203B running 12.2(18)SXF7. The loopback address is higher then the auto-rp learned address just as an FYI. The access list is a standard named access-list.
Here's how the manual says to configure:
ip pim rp-address
To configure the address of a Protocol Independent Multicast (PIM) rendezvous point (RP) for multicast groups, use the ip pim rp-address command in global configuration mode. To remove an RP address, use the no form of this command.
ip pim [vrf vrf-name] rp-address rp-address [access-list] [override] [bidir]
no ip pim [vrf vrf-name] rp-address rp-address [access-list] [override] [bidir]
(Optional) Indicates that if there is a conflict, the RP configured with this command prevails over the RP learned by Auto-RP.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...