cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1067
Views
0
Helpful
3
Replies

Multicast over 3 switches in same vlan?

jcmattos1
Level 1
Level 1

We have an IBM cluster that reside on the same vlan and communicate thru multicast staggered across 2 separate switches. 2 of the switches are CatOS and one is IOS. However, the IOS switch doesn't pass the multicast traffic over its primary portchannel trunk to the Root Switch. IGMP snooping is enabled on all three switches. Any ideas?

3 Replies 3

lgijssel
Level 9
Level 9

What type & software versions do you use?

Could we have a look at the configs?

jtantsura
Level 1
Level 1

Hi,

You should either disable IGMP snooping or configure L3 interface (which would be the querier) for this VLAN.

Regards,

Jeff

Thx Jeff, I'll try disabling the igmp snooping first should i do it to all 3 switches or just the one local? I checked our IOS configs as well for igmp querier and didn't seem to have that option available is it possibly my code 12.2(18)SXE1 or am i missing something?

FiberDist02(config)#ip igmp snooping ?

l2-entry-limit limit on the l2 entry that can be installed by IGMP snooping

limit Configure IGMP Snooping limits

source-only-learning source-only gce entries

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card