Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Multicast question

Question on the attached config.  I configured Anycast w/AutoRP and MSDP.  All seems to be working fine, however I thought I was had configured both CORE1 and CORE2 as mapping agents with "ip pim rp-address 1.1.1.1"

But when I do show ip pim rp mapping, it doesn't say it's a mapping agent.  Also, should I configure CORE1/2 for Auto RPs and MSDP?

All interfaces are configured as ip pim sparse-dense-mode.

PIM.jpg

221
Views
0
Helpful
0
Replies
CreatePlease to create content