Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Multicast routing

Hi

I am using Cisco 3750 and have connected different multicast sources in two different VLANS. I ve enabled Pim sparse-dense-mode on both the VLANS but I am not getting multicast from Source A connected in VLAN X. I am aiming to recieve the multicast on one of the ports in VLAN Y.

2 REPLIES

Re: Multicast routing

Is the receiving host in VLAN Y sending an IGMP Join for the group? Verify the source is actually sending the traffic with 'show ip mroute' and verify the receiver is sending the IGMP join with 'show ip igmp groups x.x.x.x detail', where 'x.x.x.x' is the group address.

HTH

Andy

Cisco Employee

Re: Multicast routing

Make sure also that the TTL set on the IP packets generated by the source is greater than 1 so that they can leave the local subnet. This is a very frequent issue with multicast applications.

Regards,

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
309
Views
0
Helpful
2
Replies
CreatePlease to create content