Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multicast routing

To have a multicasting application running in a network of Cisco routers/switches...Is only

#ip multicast-routing

enough.

Thanks in advance for all your help

1 REPLY
Silver

Re: Multicast routing

What you are asking..... Multicast application in term of???

if you configure to multicast routing::::

Need following commands at least:

______________________________________________

FOR DENSE MODE ONLY

ip multicast-routing (Glocal configuration mode)

interface fastethernet (Interface in which you want to enable multicast)

ip address {IP address} {Subnet mask}

ip pim dense-mode

______________________________________________

IN PIM SPARSE MODE

ip multicast-routing (Glocal configuration mode)

ip pim rp-address {this is the router name} {IP address}

EX: ip pim rp-address 10.10.10.1

interface fastethernet0/0

ip pim sparse-mode

You can user either dense mode or sparse mode.

Also i am attaching documet for you.

Regards,

Dharmesh Purohit

310
Views
0
Helpful
1
Replies